redo exhaust...

previous exhaust piping which i did in melaka was approx 1.6" in diameter... a little too small for current displacement... hence i opted 1.8" piping from extractor flexi pipe till muffler... midbullet also changed a straight flow one as my previous swirl bullet induced alot of restriction in the exhaust gas flow...

mid bullet cost me Rm100 include installation while the piping cost me another Rm160... the piping was ready-made from factory... although not mandrel bent, the finishing of the crush bent piping was good... minimal reduction in piping diameter in the bents...





still pending on a new extractor... still deciding between powerzone, hotbits or zenden... see budget first... muffler last only do la since its still applicable...